Denver's #1 Pool Leak Detection Company

Denver pools are everywhere, and not just in the obvious places. From Mile High estate properties in Hilltop and Cherry Creek to compact lap pools tucked into RiNo townhome lots, Wash Park bungalows with classic 1970s gunite, and modern installations at Stapleton's Central Park development, the city has one of the most diverse residential pool inventories in the Rocky Mountain West.

That diversity is exactly what makes leak detection in Denver complicated. A 1965 pool in Hilltop with original cast-iron plumbing has nothing in common with a 2018 fiberglass install in Central Park sitting on engineered fill. We approach every Denver job knowing the city has at least three or four very different pool worlds inside it, and we adjust accordingly.

Why Denver Pools Leak

Most Denver leaks come down to one of three causes, sometimes two or three working together.

The freeze-thaw factor

Denver averages over 150 freeze-thaw cycles per year. That is not a misprint. Warm afternoon sun pushes pool decks and surfaces above freezing during the day, and clear high-altitude nights drop them back below freezing within hours. Water inside cracks, joints, and fittings expands and contracts daily for months. The cumulative damage is worse than a Minneapolis winter where the ground freezes once and stays frozen.

Old infrastructure in established neighborhoods

Pools built in Hilltop, Park Hill, Country Club, and Wash Park during the 1960s and 1970s often still have original plumbing in the ground. Cast iron, early ABS, galvanized fittings. Materials that were never designed to flex with Colorado clay for 50+ years.

South Platte alluvial movement

Pools near the South Platte corridor sit on alluvial deposits that shift with seasonal river levels. Properties in Globeville, Elyria-Swansea, and parts of Sun Valley experience moisture variability that pools further from the river do not.

How Level Up Leak Detection of Colorado Finds Your Leak

We use LeakTronics electronic detection equipment. The process is non-invasive, your pool stays full, and we typically finish in two to three hours.

• Plumbing pressure testing isolates every line and tests independently. Supply, return, main drain, skimmer, spa, water feature lines are all tested separately so we know exactly which line is failing.
• Electronic shell scanning uses hydrophone sensors that listen for water escaping through cracks, voids, and surface failures. Walls, floor, benches, sun shelves, steps. Every part of the shell gets scanned.
• Fitting and penetration testing checks skimmers, returns, light niches, main drain covers, and water feature connections. We check each one individually.
• Equipment evaluation covers pump connections, filter unions, heater ports, and valve actuators. Freeze damage on equipment pads is common in Denver and easy to miss without inspection.

The 24-hour report

You get a complete digital report within 24 hours: leak location confirmed, photos documenting what we found, repair cost estimate, and priority ranking. This is the document you use to plan repairs, negotiate a sale, or file an insurance claim.

Neighborhoods We Cover

Denver is large and geographically diverse. We service pools throughout:

• Central / Northwest: LoDo, LoHi, Highland, Berkeley, Sloan's Lake area
• East: Cherry Creek, Hilltop, Hale, Mayfair, Park Hill, Stapleton/Central Park
• South: Wash Park, Bonnie Brae, University, Platt Park, Rosedale
• Southwest / West: Athmar Park, Ruby Hill, West Highland, Sloan Lake
• North: Globeville, Elyria-Swansea, Sunnyside, Berkeley

Signs Your Denver Pool Is Leaking

• Adding water more than once a week (more than evaporation can explain)
• Wet spots in landscaping or sogginess around the equipment pad
• Cracks appearing or growing in the pool deck or coping
• Water bill spike with no obvious cause
• Pool chemistry that refuses to stabilize
• Autofill running constantly

If you are seeing any of these, call. The earlier we find it, the less your wallet and your property absorb.